S-SL Maintenance Guide
How does the split/splitless injector work?
The SCION Instruments Split/Splitless (SSL/ 1177) injector shown in Figure 1, is designed to operate in two modes; split and splitless. This can be programmed in the instrument method. A split/splitless program allows customers to work with a wide range of sample concentrations. Within CompassCDS, you can easily switch between the two modes based on the concentration of the samples.
The SSL injector is isothermal, so it can only be programmed to a constant temperature during analysis. The injector temperature is application dependant but should be set high enough to ensure that any target analytes, sample matrix, and diluent are all volatilized effectively in the injector. Capillary columns are commonly used with the SSL injector. Learn more about SCION’s injectors in our Injectors Guide. It is important to note that liner and solvent choice, method temperature and injection volume are crucial to SSL injection and if not chosen correctly can cause issues such as backflash.
Figure 1. S/SL (1177) injector diagram
Maintenance schedule
It is recommended to have a maintenance schedule within your laboratory. The frequency of which maintenance will be required is based on the applications being run in your laboratory and the sample matrix. Performing maintenance is important to prevent contamination and optimize the system reliability and reproducibility. Regular maintenance includes changing the liner, septum and O-ring.
Carrying out regular maintenance
Make sure that you work in a clean workspace to prevent contamination and always wear clean gloves!
Before beginning any maintenance on the SSL injector make sure that the injector is cooled down below 100°C. Then turn OFF the column flow.
- Unscrew the top of the injector, take out the septum
with tweezers or clean gloves. - Unscrew both screws and lift up the injector head.
- Take out the liner which will be attached to the O-ring.